![]() |
|
|
|
#1
|
||||
|
||||
|
A bit of a minor update. I recently acquired my first CRT tester. It is a Sencore CR 161. From what I have heard online, Sencore is a trustworthy brand. After reading the instructions and manual, I quickly learned how to use the tester and began using it to test all the CRT's I have.
The one in this motorola tv is supposed to be 6.3 volts and hi bias mode. At this voltage red and green color guns were good. Blue however was on the weak side. However at 7.3 volts which would simulate what a tube brightener would do to the emissions, emissions improved for all three guns notably, and blue went solidly into the good territory. No shorts were found for this CRT which is good to know. While this CRT has many hours on it, I am a bit surprised that emissions seemed higher than I would have guessed based on the alleged history and heavy use of this tv over the decades (barber shop tv). I was fairly impressed. |
|
#2
|
||||
|
||||
|
I used Deoxit 100 to spray into the CRT socket and tube sockets...I think I screwed the tv up. I am now only getting a horizonal line that changes color but no vertical deflection. (Same symptoms as the Heathkit tv before it ultimately failed and now has no picture or signs of life) Does Deoxit 100 cause shorting?
I fear I may have ruined the heathkit tv and likely burned the yoke coil. I turned the motorola tv off. as soon as I saw the horizontal line. (It got to that point with normal audio when the variac was turned up to around 80ish volts or so) Normally the picture gradually expands out. Also of note is that I used 99% isopropyl rubbing alcohol to try and clean the grimy pincushion circuit board (The tv sat for several days so what little water was in the mixture likely dried off for sure), I wonder if it smeared grease around on the board and may have caused a short there. I am at a loss and pretty discouraged that the tv is now worse off than where it was before. |
![]() |
| Thread Tools | |
| Display Modes | |
|
|