Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Early B&W and Projection TV

Notices

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #11  
Old 12-05-2022, 03:02 PM
Chris K Chris K is offline
VideoKarma Member
 
Join Date: Jun 2022
Posts: 1,534
Quote:
Originally Posted by Phil Nelson View Post
Also note jr_tech’s comment about checking the heater connections throughout the tube strings. On page 2 of the Sams schematic, the diagrams at the far lower left show all those heater connections.

You can see that pin 7 of V20 connects to pin 8 of V21, and so on down the line. Using your ohmmeter, you can check these connections for continuity, working from one tube to the next.

Phil Nelson
OK I measured all of the resistance values as instructed in the Sams. I checked filament continuity in the strings and they are all fine with no breaks. I thought I would start describing the situation with the 35W4 negative rectifier as that's one of the first power tubes to come off the ballast. All of the pin resistances are fine except for pin 5 that's supposed to be 33k and it's unreadable jumping all over the place from 0 ohms to 4 meg when I put the probe to it. Pin 5 of it goes to pin 8 of the HV oscillator 25L6 but all of the pin resistances on the HV Osc. are close to the table values. Then on the HV rectifier 1B3, there are many pins off value. Pin 4 is bouncing all over like pin 5 of the 35W4 and pins 2 and 3 that are supposed to give infinite values are reading low ohms; 21 for pin 2 and 0.3 for pin 3. Arughhhhhh! Does that give you any enlightenment? I did replace all of the electrolytics. The TV worked after I replaced them...sorta but these most recent issues appeared after replacing about 15 resistors.

Last edited by Chris K; 12-05-2022 at 03:12 PM. Reason: Update
Reply With Quote
 


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 10:07 AM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.