![]() |
|
|
|
#1
|
||||
|
||||
|
IIRC my HDML cloner box (which I use more for recording HDMI, and occasionally component and composite sources to USB than as an upscaler despite it being capable of that) will take a 4X3 composite input and convert it to a 16X9 HDMI output consisting of the composite signal in the center pillarboxed by black bars on either side...I can double check for you later tonight after dinner.
__________________
Tom C. Zenith: The quality stays in EVEN after the name falls off! What I want. --> http://www.videokarma.org/showpost.p...62&postcount=4 |
|
#2
|
||||
|
||||
|
Thank you, that will help...
|
|
#3
|
||||
|
||||
|
The only practical way to deal with this is to use a cable box with a "zoom" button on the remote, or to use the "zoom" function on the TV itself if such exists (as a button on the front panel). Some older Zenith color TVs had a "zoom" button which caused the image to fill the screen if it wasn't full-screen already; however, I am not aware of any other brand of television having this feature, or what would or might happen if the zoom button were to be pressed when the TV was already displaying a full-screen image.
BTW, the black bars at either side of the picture (when viewing a 16:9 image on an older TV designed for 4:3 aspect ratio) will not damage your older TV's CRT, as there is no video contained in or on these bars. However, it is always best to expand the picture so it fills your TV screen, even if it causes some distortion of the image.
__________________
Jeff, WB8NHV Collecting, restoring and enjoying vintage Zenith radios since 2002 Zenith. Gone, but not forgotten. |
|
#4
|
||||
|
||||
|
It does work the way I remember it working. The below picture shows the 16X9 HDMI output on my 16x9 Sony HD-CRT TV (which has a fair bit of overscan) and the 4x3 input on my 1971 Zenith..There is a bit of time lag in doing the conversion so the Zenith at bottom is a few frames ahead.
The device I'm using to convert composite video to HDMI is a ClonerAlliance HDML Cloner Box Pro Model CA-998P...I bought it off Amazon circa 2017. In the last year or two one of the YouTube channels I follow did a review of it as an analog capture device so I think it's probably still for sale new. If you watch the YouTube video I made Record Anything To D-VHS I show and briefly talk about the cloner box mid video...I also used the cloner box to capture the component output of the direct VCR footage in the video.
__________________
Tom C. Zenith: The quality stays in EVEN after the name falls off! What I want. --> http://www.videokarma.org/showpost.p...62&postcount=4 Last edited by Electronic M; 10-13-2022 at 04:47 PM. |
![]() |
| Thread Tools | |
| Display Modes | |
|
|