Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Early B&W and Projection TV

Notices

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #11  
Old 07-06-2022, 06:39 PM
Yamamaya42's Avatar
Yamamaya42 Yamamaya42 is offline
VideoKarma Member
 
Join Date: Nov 2018
Location: Round Rock TX
Posts: 3,253
Quote:
Originally Posted by Chris K View Post
So my RF generator is set at 21.25MHz. The grid on the 1st audio tube, 6AT6, is pin 1. Do I need to ground the black generator output lead or just touch pin 1 of the 6AT6 with the red lead from the Knight? Sorry for the very basic questions here but this is virgin soil for me!
this set is very close to my FADA 895, which is a RCA630TS clone.

the 6AT6 is the 1st audio level amp, it also serves as a bias clamper ( diode ) as this set is pre-AGC and has a " picture control" like my FADA,

like someone mentioned above to test the audio out section, you can simply clip on to the center wiper of the volume control, and feed in any sine wave in the audible range, to test it. this will also insure that you are on the isolated side of the grid via the .01 cap , no risk of loading loading thing down hooking up to that point.
__________________
=^-^=
Yasashii yoru ni hitori utau uta. Asu wa kimi to utaou. Yume no tsubasa ni notte.
いとおしい人のために
Reply With Quote
 


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 12:11 PM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.