![]() |
|
|
|
#1
|
||||
|
||||
|
My folks had a Curtis-Mathes (or is it Mathis) of about this vintage. I seem to recall the cabinet was better built than the chassis. The chassis was just a copy of a RCA.
|
|
#2
|
||||
|
||||
|
Quote:
The TV chassis in these combos may have been RCA clones, but were good sets nonetheless. RCA, after all, was a pioneer in electronic television, so they did not skimp or cut corners anywhere. My first color TV, in fact, was a Sears Silvertone table model, with an RCA CTC-12 (IIRC) chassis and a round CRT. The set lasted me about three years, then, when I tried to replace a tube, one of the video circuit boards cracked and ruined the set for good, to my utter disappointment. I found another Sears (RCA) TV, this one with a 17- or 19" CRT (again IIRC), a few years later; this set, thankfully, lasted me much longer than the larger round Silvertone set did. I got rid of that 17" Silvertone when I bought my first new color TV, a Zenith 13" portable. I bought another Zenith 13" portable, this one with one-knob electronic tuning, a few years later. When digital TV came along, I put the Zenith TVs in storage (eventually getting rid of both when I moved in 1999) and bought a 19" Insignia HDTV, replacing it a few years later with my current TV, a 32" Insignia flat screen. BTW, many if not most color TVs made in the 1950s to about the 1970s did incorporate RCA chassis; these sets, however, had many different brand names on the cabinets, not just RCA. These TVs were marketed under almost every major brand you could imagine, except Zenith; for some reason, Zenith either would not or could not use RCA chassis in any television bearing the Zenith brand name--maybe it was a copyright issue.
__________________
Jeff, WB8NHV Collecting, restoring and enjoying vintage Zenith radios since 2002 Zenith. Gone, but not forgotten. Last edited by Jeffhs; 07-09-2022 at 04:10 PM. |
|
#3
|
||||
|
||||
|
Happy Birthday Jeffhs !
|
|
#4
|
|||
|
|||
|
Quote:
All the other firms, even the private labelers bought genuine RCA built chassis, up to and including the CTC15. After RCA came out with the CTC16, they allowed the other firms to clone the CTC15. Getting back to Curtis Mathes, I worked on a cheapie, 1968 roundie CM set. It was a clone of that lousy CTC20. |
![]() |
| Thread Tools | |
| Display Modes | |
|
|