![]() |
|
#13
|
||||
|
||||
|
I played with the vertical again yesterday and got it a bit better. Its still got problems at the bottom.
The vertical linearity control is all the way clockwise. The vertical was the circuit that originally sick, but I never found anything wrong with it. I didn't measure every part out of the circuit since it started working when removed from the case. I think the next step if to remove it from the case (again ) and check each and every cap and resistor, fix any that were even a tiny bit off, the power up and use a scope. |
| Thread Tools | |
| Display Modes | |
|
|