![]() |
|
|
|
#1
|
||||
|
||||
|
Quote:
__________________
=^-^= Yasashii yoru ni hitori utau uta. Asu wa kimi to utaou. Yume no tsubasa ni notte. いとおしい人のために |
|
#2
|
|||
|
|||
|
I measure 258 at L31 and the HO plate cap
|
|
#3
|
||||
|
||||
|
I was a bit confused by when you said '#Voltage at H Out anode cap is 140 “
That 258v there is normal and enough for it to work. Next thing to look into is, why did you see a g1 voltage that was 1v too low? Bad 5GH8A? These go bad a LOT, you can try to swap with the one in v3 to see if that changes anything if you do not have a spare. Also, this set dos something weird with the cathode of the HOT and has it wired to the circuit breaker. You could try to tie it directly to ground for a bit, to see if that makes any difference, the breaker may be bad and not grounding the cathode enough.
__________________
=^-^= Yasashii yoru ni hitori utau uta. Asu wa kimi to utaou. Yume no tsubasa ni notte. いとおしい人のために |
![]() |
| Thread Tools | |
| Display Modes | |
|
|