Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Rectangular Screen Tube Televisions

Notices

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #8  
Old 01-16-2022, 05:41 PM
ARC Tech-109 ARC Tech-109 is offline
Retired Batwings Tech
 
Join Date: Jun 2020
Location: Planet Earth
Posts: 612
The issue here isn't with the CRT, your pictures confirm this. Now is there any chance a 6EJ7 hasn't been transposed or replaced with a 6EH7? I'm guilty of this and spent many hours chasing my tail looking at low video output levels. Double check this.
Tubes are ballpark devices anyway so I wouldn't worry about a few volts, its more about the actual differentials.
I'm trying to look at V4 now but the google supplied schematic has this part cutoff, piecing it together I'm wondering if the delay line has opened or a bad solder connection at the base of the tube where the terminal is crimped down, I've seen these open here before. Check the delay line for continuity, it should be several ohms but not a complete open except on one terminal which is an internal shield and grounded. Look at the base of Q1 video amp and do a continuity check from there to the cathode of V4 and you should find another 1200 ohms on top of the delay line. The cathode sets up the bias for Q1 and finds its ground thru R71.
The lack of 3V on the V4 grid coming from the video detector tells me there is a gain issue in the IF amp itself and this is why I question whether one of the IF tubes has been transposed. Check the cathodes of V1 and V3 to verify they are under about 30 volts to ground. Have any of the IF coils A8 thru A11 been touched at all? The slightest change here will have a dramatic effect and require a sweep marker generator to get back on track, same with the chroma coils. I'm speaking from experience here they can be a real pain without the right test equipment. With a good strong IF signal coming into A7/A8 the detector diode will put out well over -3 volts of video signal, plenty enough to drive V4 into cutoff.
I have a Zenith 20YCI37 schematics buried somewhere and will unearth it, they're similar enough for me to help more than hinder. Give me a day to locate and study it for some answers. You have a real gem there and I'd really like to see you get it going.
I wouldn't worry about the line voltages, anything between 115 to about 120V is acceptable to the world of tube TV's
Reply With Quote
 


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 06:41 AM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.