![]() |
|
|
|
#1
|
||||
|
||||
|
Quote:
Please don't mess with the IF adjustments. Centering consists of spreading or bringing closer the 2 circular rings along with moving them together. Fiddling with them should give you an indication of the direction you need to go. There is no DC restoration. You should be able to get a full snowy white raster with no signal going to the tuner. Your brightness control should be able to take it from bright to complete darkness. On mine I found the cathode bypass cap(C2) on the 6CM7 vertical output tube really needs to be at least 60uf in order to get decent vertical linearity. I tried a 47uf and that was a no go. |
|
#2
|
|||
|
|||
|
Quote:
As far as the full bright snowy raster goes that is a no go, the top part of the screen is completely dark, and trying to adjust the centering rings doesn't affect it any, there is supposed to be a ion trap on this TV but I don't know where it is in reference to the rest of the picture tube, the Sams shows it as being part of the yoke but I don't see anything on the yoke assembly that looks like an ion trap. Any ideas? |
|
#3
|
||||
|
||||
|
Quote:
Also both of my sets have a width sleeve - a thin piece of brass sheet wrapped around the neck inside the yoke. Moving that in and out of the yoke varies the picture width. |
|
#4
|
|||
|
|||
|
Quote:
And with the base of the CRT already being somewhat damaged I don't want to force anything and risk damaging the CRT any further. I have a picture posted below showing what I mean. Also my TV Analyst Came today, and its intact, but I have no idea if it functions or not because I don't have any cables for it yet. I would guess that the probes for this thing could still be bought seeing as B & K is still around and they still make test equipment and probes for them. |
|
#5
|
|||
|
|||
|
Quote:
That set was stored in a damp environment, as it shows mildew all over. |
| Audiokarma |
|
#6
|
||||
|
||||
|
Good to hear the B&K showed up. The only cables you need are a shielded 50 ohm BNC cable to alligator clip leads and a couple un-sheilded male pin plugs to alligators clip leads. Those pin connectors are the same as what commonly came with inexpensive VOM meters back in the day. Nothing special about them and I'd be shocked if you don't already have the BNC cable with all the test gear you've told us about.
But before worrying about connecting any signal to the Bugeye, get your CRT sorted out. You don't need any video signal to get a raster. |
|
#7
|
|||
|
|||
|
Quote:
I figured out the ion trap, it was just stuck in place because it hadn't been moved in years. Another weird thing is that even adjusting the ion trap there's still a dark spot on the top of the screen when I adjust the linearity and height adjustments. And yes I did have the correct connectors for this thing, the same connectors I used for my signal generator is the same connector that TV Analyst uses (BNC to alligator clip leads.) |
![]() |
| Thread Tools | |
| Display Modes | |
|
|