![]() |
|
|
|
#1
|
|||
|
|||
|
Quote:
I picked up a cheap 100mA focusing coil from ebay that I need to build a mount bracket and a circuit around. But i dont know if that is enough current or not. I may make a pitstop back down to the tv shop warehouse and have another look around to see if i can find a junker set i can steal a coil from if not. |
|
#2
|
||||
|
||||
|
Quote:
according to frank.pocnet.net datasheets, BOTH the 17FP4 and the 17HP4 have electrostatic focus and the same bias of 12L https://frank.pocnet.net/sheets/127/1/17HP4.pdf https://frank.pocnet.net/sheets/127/1/17FP4.pdf and thus are pretty much the same. Meaning focus is p6 and magnetic focus wont work. Is the " 17FP4" above an error? cause it does show it as ES focus.
__________________
=^-^= Yasashii yoru ni hitori utau uta. Asu wa kimi to utaou. Yume no tsubasa ni notte. いとおしい人のために |
|
#3
|
|||
|
|||
|
Quote:
![]() ![]() |
|
#4
|
||||
|
||||
|
Quote:
__________________
=^-^= Yasashii yoru ni hitori utau uta. Asu wa kimi to utaou. Yume no tsubasa ni notte. いとおしい人のために |
|
#5
|
||||
|
||||
|
Have you tried the tube? Quite possibly it will focus just fine with no focus magnet or focus voltage. If you read the typical operational conditions there's a note C that specifies the preferred condition for best focus.
|
| Audiokarma |
|
#6
|
|||
|
|||
|
No I need to restore the set first. I just wanted to secure a CRT before i even tried becuase there would be no point. the original CRT was an open cathode. I tried to weld it but i was tapping too hard on the CRT and necked it.
|
![]() |
| Thread Tools | |
| Display Modes | |
|
|