Quote:
Originally Posted by vortalexfan
...I went back and checked my voltages again, and the B+ voltage going to C3B and R54 and R56 is around 210V...
|
OK. That's close enough for now. At least you've verified B+ on C3b.
The identical voltage should be appearing on pin 6 (screen grid) of the 5AQ5, and on the bottom of the output xfmr primary (red lead).
In other words, there should be solid continuity (zero ohms) twixt all those points. (Forget the negative voltage issue for now) Main thing is to find out what connection's gone open.
With the set OFF, and an ohmmeter set to RX1, connect the black lead to pin 6. With the other lead, check for zero ohms to bottom of xfmr primary (red lead), and to C3b. You'll probably find the connection to C3b is what's open.
BTW, also check the xfmr primary for a few hundred ohms between pins 6 and 5 (plate) of the 5AQ5.
Once this is all sorted out, check for solid continuity (zero ohms) from C3's can to ground. Any resistance here could be contributing to the 'negative voltage' condition.
12-09-2021, 02:01 PM
Threaded Mode