![]() |
|
|
|
#1
|
|||
|
|||
|
I don't know how you could of missed this, but C50 has a lot more to do with the audio output circuit than you think it does, for example the 245V B+ supply is shared in common between the Audio Detector Tube and the Audio Output tube, and both supplies are filtered through C3B which are their common tie point in the 245V B+ supply through R54 and R56 (R54 feeds the 245V B+ supply line to the Detector Tube and R56 feeds the 245V B+ supply to the output tube and both of those resistors are tied to the positive side of C3B which is tied to chassis ground just like it was originally when it was in the old can cap, if you look at my schematic excerpt and my markings explaining where the negative voltages are being measured at and where the common points are in the two "unrelated circuits" you'll see that I'm not nuts in how I'm following this circuit layout and what I mean by the voltages after C50 are negative unless I reverse my leads.
|
|
#2
|
||||
|
||||
|
Quote:
Last edited by Kevin Kuehn; 12-08-2021 at 02:14 AM. |
|
#3
|
|||
|
|||
|
Quote:
|
|
#4
|
||||
|
||||
|
Quote:
|
|
#5
|
|||
|
|||
|
I did disconnect it earlier and it did make somewhat of a difference but not a whole lot I wasn't getting negative voltages anymore but I was still getting only 22V on pins 5 and 6 of the 6AQ5 tube, so in that sense the removing C50 didn't affect the voltages but it did eliminate the weird negative voltage issue that was going on to the right of C50 in the audio circuit.
|
| Audiokarma |
|
#6
|
||||
|
||||
|
Quote:
Then we can hone in on why the voltages are so low. Do you have a new capacitor you can replace C50 with?
|
|
#7
|
|||
|
|||
|
Quote:
Anyways I'm very sorry I'm frustrating you, and believe me this is frustrating me just as much as it is you, because I was hoping that these Zenith TVs would just work after being recapped like my Meck TV did but unfortunately that's not the case here, these Zenith TVs are being stubborn and are not wanting to work correctly even after a recap job. |
![]() |
| Thread Tools | |
| Display Modes | |
|
|