![]() |
|
|
|
#1
|
||||
|
||||
|
Do you have any test equipment that you can use to inject video and or IF signals (also a power isolation transformer to keep the hot chassis from frying your test equipment)?
The voltages mostly look within reasonable tolerance (in tube equipment a 20-30% B+ and general voltage reading tolerance is not unreasonable).
__________________
Tom C. Zenith: The quality stays in EVEN after the name falls off! What I want. --> http://www.videokarma.org/showpost.p...62&postcount=4 |
|
#2
|
|||
|
|||
|
Predicta Holiday Issue
Thank you for responding.
I have a B&K Isolation Transformer, and a B&K Model 1077 Television Analyst. I have injected an RF signal at the antenna terminals (nothing). I have input an IF signal at the 3rd IF amp (very faint, fuzzy test pattern outline, no sound). I repeated this at the 2nd and 1st IF amps, with the same results. I thought maybe the low 435V Boost might be part of the dim raster issue, but I can't seem to correct it. |
|
#3
|
|||
|
|||
|
Predicta Holiday
I just re-ran the 3rd IF test, and have an audio tone. I adjusted the Horizontal Range, Height, and Vertical Lin controls, and have an image! A bit distorted though (pulled down from the top,etc). I have attached an image (sorry for the glare). I re-ran the RF test, and still no sound or picture. Maybe the tuner. I will re-run the 2nd and 1st IF tests.
|
|
#4
|
|||
|
|||
|
Re-ran the 2nd and 1st IF tests. Still get an image and tone. The picture is still pulled down from the top. The vertical centering magnet doesn't seem to help.
|
![]() |
| Thread Tools | |
| Display Modes | |
|
|