Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Solid State CRT Televisions

Notices

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #3  
Old 03-28-2021, 08:37 PM
kf2dx kf2dx is offline
VideoKarma Member
 
Join Date: Feb 2008
Posts: 6
Worked on a lot of these back in the day. Memory is used external variable supply to run horiz osc 19V.It should start at around 5-6 volts.( It was important to run external supply through a diode to prevent damage to supply when sets scan derived 19 V source came up). You could then bring the set up on a variac while monitoring the collector of the SD613 with a scope and the 130 V B+. I remember there is at least one electrolytic coupling cap between the oscillator IC and the H driver that would change value and distort the drive and cause repeat SG613 failures. Other issues were bad solder dips , good practice to re-solder all SG613 collector circuit components. Never had a bad flyback or tripler in any of those. Those 114 degree sets had fantastic pictures if CRT was strong really outshined all the competition at that time. Actually enjoyed working on them because you had something really nice once repaired and set up.

73-
Paul
Reply With Quote
 


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 06:41 AM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.