![]() |
|
#2
|
||||
|
||||
|
On both sets check:
1) the G-2 is not too high. Should be apx 450 VDC. at CRT pin 2) on the CRT board there are 3 identical resistors ( apx 18K 2 watt) Where they join be sure you have apx 200 VDC. 3) if you turn down the bright, contrast & color level you should be able to extinguish or nearly so the pix. Turning back up the brite & contrast should show a constant B&W pix as you go up. If it changes color as you go it may be the CRT. good luck. 73 Zeno ![]() LFOD ! |
| Thread Tools | |
| Display Modes | |
|
|