![]() |
|
|
|
#1
|
||||
|
||||
|
hey i suggest of doing a setup and if it makes a nice picture that you could live with just do it and keep an eye out for a good tube, but if i remember right there's a service menu you pull up and you can set your r g b bias controls and drives to get a good bright grayscale picture. i always liked a brighter picture with the contrast turn to just about middle. try that first.
|
|
#2
|
|||
|
|||
|
I went in and turned down my Picture to about Midway Point. I then bumped up the bright to just a little past the half way point. I had turned up G2 Previously so since I bumped up the brightness I gradually backed down on the G2 Setting. It doesn't seem to show much blooming of the blue set this way. I had to turn up the Sharpness some too. The picture is a little dark, but not bad for the way I had to adjust settings to keep the blue smearing down to minimum or not at all. I'm not sure how you get into the Service Menu on these 1996 Sets either? I thought someone said one time you hold down on the menu button or have to enter a code? Thanks for your advice.
Last edited by Console User; 12-28-2020 at 07:23 PM. Reason: No longer needed |
![]() |
| Thread Tools | |
| Display Modes | |
|
|