Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Solid State CRT Televisions

Notices

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #8  
Old 09-26-2020, 12:13 AM
RevennaFox's Avatar
RevennaFox RevennaFox is offline
VideoKarma Member
 
Join Date: Jan 2019
Posts: 4
I've swapped Q802 and replaced fusistor R417 with a 500mA fuse. Since the meltdown mentioned above I haven't been able to get anything out of the flyback, no HV, no filament voltage, and no LV. While measuring voltages on the bottom of the board I heard a sound like glass breaking and quickly powered everything down.

I thought maybe the regulator had overheated and the sound was the little mica insulating sheet cracking but it turned out to be the sound of R808, the big 210Ω/20W power resistor, overheating and splitting in half lengthwise. It was so hot I had to wait about 10 minutes before I could remove it. Strangely enough, it still registered close to it's stated value. I don't have any resistors that big laying around so I'll have to wait until I order some parts to replace it.

Bypassing the regulator and R808, I tried lowering the input voltage to about 90V with a variac to get exactly 125V DC going into the flyback's primary through fusistor R417, with the result being to instantly blow that fuse. Would I be correct to assume that I've damaged the flyback while diagnosing the power supply issues?
Reply With Quote
 


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 09:27 PM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.