![]() |
|
|
|
#1
|
||||
|
||||
|
W125 looks like the contrast control.
Sets with intercarrier sound (sound IF gets fed by the video IF) sometimes have the contrast effect sound gain if the contrast changed the video IF gain as a part of their design...Sets with AGC don't have this issue. Your description of the picture is hard to follow. Could you post a picture to clarify? If my guess at your meaning is correct it sounds like you get snow with no signal, and a weak picture that is unsynchronized in both sweep axes with signal...that would point to 2 problems. Bad sync separator (or issues with the sweep circuits). And poor gain in the tuner, IF and or video stages(could be a bad video detector diode too).
__________________
Tom C. Zenith: The quality stays in EVEN after the name falls off! What I want. --> http://www.videokarma.org/showpost.p...62&postcount=4 |
|
#2
|
|||
|
|||
|
Thanks for the reply. The contrast potentiometer is W821 which I replaced with no difference. W125 does nothing when turned. The I.F. can with the demodulation diode was also replaced with no difference. The tuner was also replaced with no difference. I will try and explain the problem in more detail. With no signal, I have snow and static from the speaker. When I tune in, I get crystall clear sound, the picture jumps during tuning as it should, but instead of snow turning into video, it turns into a somewhat clear raster with random dots and bars dancing according to the movie action. Tomorrow I will try filming the problem.
|
|
#3
|
|||
|
|||
|
W125
It isn't very clear to me, but possibly the triode section of Ra104 is some sort of video derived agc. It appears to be feeding back down the chain to the IF. If this is true then W125 would be an agc control. It is a bit difficult to tell connections from wires crossing each other, and not connected, on the schematic. It sounds to me as if you may have a problem in the IF causing low video output and low sync level. I had a very similar problem with a set one time that turned out to be caused by someone adjusting the IF transformers WAY out of alignment. Good luck with it and please let us know what you find.
|
|
#4
|
|||
|
|||
|
Oh man, that was my biggest concern...If video alignment is the case, I'm done. I don't have the equipment for such procedure. The weirdest part is that I have checked ALL the parts in the video I.F.
|
|
#5
|
|||
|
|||
|
I forgot to mention that the original flyback had shorted primary. I replaced it with the one from the donor set. It is the same tv with two inches smaller screen. To my knowledge, the horizontal circuit has nothing to do with the video. With the new flyback, the horizontal and high voltage are normal and the temperature of the primary is always 58 degrees Celsius.
|
| Audiokarma |
![]() |
| Thread Tools | |
| Display Modes | |
|
|