Quote:
Originally Posted by Kevin Kuehn
Sounds like you found your problem, hopefully before you damaged the winding. Partial grounding of one side of the filament could have something to do with the hum too. For such reasons it's a good idea to keep the set plugged into a dim bulb tester until you're very confident everything is working reliably.
|
The problem with this thing is that the wiring is so hard to get to in this portion of the chassis and trying to clean the solder off the holes where the wires go into on the tube sockets is a pain in the butt because the ouptut and the interstage transformer are in the way and I can't move them very easily.
08-07-2020, 03:09 PM
Threaded Mode