Quote:
Originally Posted by Notimetolooz
There is a component on schematic of the vertical sweep circuit area that you posted that is labeled PW500-A. It is probably a "couplate" (there are other names for the type), a collection of capacitors and resistors on a small ceramic plate. Couplates have many leads. They are difficult to test completely. Pretty difficult to find replacements for them but from the SAMS info they can be built from scratch.
|
I have a second chassis for this tv (chassis A), it is the original with a dead main transformer. The chassis currently in use (chassis B) was recently found and purchased from TheRadiolaGuy.
I can pull boards from it if needed (chassis A), I checked the little board today (chassis B) and found correct components, soldered a few spots on it and on the PW500. Still stuck with a flickering split image (chassis B).
I may take a break from the working chassis (B), and disassemble the other boards on the dead chassis (A). I am VERY lucky to have a duplicate of everything; including the Height/Vertical Linearity pots (it is one unit), it may be failed on the working chassis (B).
The resistors inside the double Height/Vert resistor unit/pot may be bad.