Quote:
Originally Posted by BandDirector
The rivet did fail, and I tried to make a electric tape line wall so that the leads don't make contact with any metal. The lytic was a polarized 10 mfd 450 volt, so it was extremely high voltage, the spec calls for 8 mf at 10 volts. I have a 4.7 mf at 50 volts floating around.
|
Usually you can use a machine screw with a nut to replace the rivet. I'm assuming the cap was the high pass crossover for the tweeters, in which case it needs to be close to original micro-farads for the frequency roll-off to be correct. Voltage not so critical. But the large speaker should sound pretty decent by itself.