![]() |
|
|
|
#1
|
||||
|
||||
|
Quote:
Just for the heck of it , post up a few closeup pics of some of the caps you replaced , who knows something may look familiar (or unfamiliar) enough to spot the problem |
|
#2
|
|||
|
|||
|
Sorry, I shoulda been more specific. 'Ground end' simply means the lowest potential or no-signal end. In this case, there's a 40 ohm resistor (R22) from there to chassis ground. See if there's 40 ohms from the low end lug of the control to chassis.
(R22 may be physically distant from the control since it's part of the negative bias supply circuit.) Last edited by old_coot88; 06-24-2020 at 05:42 PM. |
|
#3
|
|||
|
|||
|
Quote:
I have some pictures of the radio underside showing the capacitors I changed, there was one little spot that looked like it could of been from a component that was cut out at some point in time but there wasn't anything near by that matched it so I chalked it up to maybe a sloppy part placement job from the factory. See pictures below. And yes there's 53 Ohms on the low side of the volume control pot to the chassis, so that means that the negative side of the volume control pot is fine it seems. Last edited by vortalexfan; 06-24-2020 at 08:22 PM. |
|
#4
|
|||
|
|||
|
Not necessarily. There could still be an open in the resistive element itself. If you float the negative lug (disconnect everything from it), see whether the element measures called-for resistance, or if it's open.
|
|
#5
|
|||
|
|||
|
Quote:
|
| Audiokarma |
|
#6
|
|||
|
|||
|
Disconnect only what's going to the negative (low end) lug. Measure from that lug to the wiper lug, and rotate the control stop-to-stop. The meter should show a smoothly-changing ohms value, from very low to very high. (The wiper is the middle lug between the bottom and top-end lugs.)
Or does the meter show open circuit (infinite resistance) thru the full range of rotation? Last edited by old_coot88; 06-25-2020 at 01:10 AM. |
|
#7
|
|||
|
|||
|
Quote:
The biggest give away was that the volume control pot wasn't measuring open but it was being rather difficult to turn so I took some contact cleaner and sprayed it into the volume control pot and sure enough that piece of capacitor lead wire flew right out of the pot and it now rotates perfectly. |
![]() |
| Thread Tools | |
| Display Modes | |
|
|