![]() |
|
|
|
#1
|
||||
|
||||
|
The VA62 is good for a lot of things but aligning the IF is something it isn't that good for.
|
|
#2
|
||||
|
||||
|
Quote:
Just intrigued by the prospect of the alignment procedure. I remember at a VA48 seminar when those were new the field rep ran the IF slugs all the way in on a TV (don't recall what kind but it was a color portable) and did the alignment with the bar sweep and a scope. I wasn't paying particular attention as the coffee and donuts were being put out (and I was like 16 at the time) but he had it done in about 10 minutes, and the picture looked fine. The reason I asked is that I know there's a mod developed by two gents from this forum for the 62 that will let it get into the 25mhz region where I have a 1951 TV that could use a touch up. I have a B&K 415 that we bought new, but that doesn't do anything but 45mhz. John |
|
#3
|
||||
|
||||
|
Was that seminar at the Sheraton inn Boxboro Ma. ? Was there &
we bought the package. I liked Sencore stuff. Looked nice & was geared to the TV biz. Anyhows they used a Zenith CC2 (19EC45 etc) for the demo & did the IF's in jig time. Only beef with Sencore was it wasnt as reliable as others. Cold joints under harmonica connectors & bad CRT cables on testers. And they did not give anything away ! 73 Zeno ![]() LFOD ! Quote:
|
|
#4
|
||||
|
||||
|
Quote:
No, it would have been in CT, maybe Meriden or Waterbury. You're right; Sencore was never shy about charging for anything they sold. It was before my time, but Sencore had a horrid reputation for quality earlier - like the 60s and 70s. I remember a few comments from seasoned techs at those seminars. They got their act together later. My Z meter was trouble free from 1985 until early this year, when it started getting slow to acquire a number and drifted. I used a handheld ESR meter to pick off the worst offenders and it's been running perfectly since. Some day I'll recap it. John |
|
#5
|
||||
|
||||
|
Used to see a lot of Conn techs at Boxboro, Marlboro, Worcester, & especially
Springfield of course. I had a 40 hr job & when not there I contracted other shops. I went to every seminar I could. One cat I never worked for but he paid me to go to an RCA seminar so he could keep his warranty status. I always took 2 sets of training manuals & my regular job loved it. Those TM's were worth there weight in gold with the rapid evolution of SS sets. Ah the good old days. 73 Zeno ![]() LFOD ! |
| Audiokarma |
|
#6
|
||||
|
||||
|
Quote:
The theory of those TVs was given in great detail. Even the full service manuals of later RCAs like the 169 series has about 10 pages of theory before the schematics. A schematic only shows so much, but without the theory, the protocol of the software and the communications between all the ICs is something that required explanation. Quote:
John |
|
#7
|
||||
|
||||
|
Quote:
__________________
Tom C. Zenith: The quality stays in EVEN after the name falls off! What I want. --> http://www.videokarma.org/showpost.p...62&postcount=4 |
![]() |
| Thread Tools | |
| Display Modes | |
|
|