![]() |
|
|
|
#1
|
|||
|
|||
|
Quote:
The 6CD6 has a totally different pin-out. The 6BG6 might work in a pinch. All the side-mount 16" chassis used a 6CD6. |
|
#2
|
|||
|
|||
|
IIRC, plate connector cap is different diameter too. Like about 1/4" for the 'BQ6, 3/8" for the 'CD6.
|
|
#3
|
||||
|
||||
|
Seems like the wrong tube is the problem.
If it still doesn't work you can check that the horizontal output is running, and therefore there should be HV, by bringing a compact fluorescent bulb near the horizontal output or flyback. If it lights up those are good. Last edited by Notimetolooz; 04-18-2020 at 12:42 PM. |
|
#4
|
|||
|
|||
|
You can eyeball the inside of the plate connector, to see whether it fits a small or large diameter cap. If large, it's not 6BQ6.
|
|
#5
|
||||
|
||||
|
Why would both tube numbers be stamped near that tube socket?
|
| Audiokarma |
|
#6
|
||||
|
||||
|
Thanks for all the help...
I was wondering why the HV lead wire cap didn't fit on the top of any 6BQ6 tubes I had! I'll have to just go ahead and order a 6BC6 tube... Of course I have a million tubes, but not a 6BC6!! I am assuming they stamped both numbers on the chassis next to the socket for different chassis circuits? Will update once I get the new tube! Thanks again! |
|
#7
|
||||
|
||||
|
Quote:
Im must be getting old!! |
|
#8
|
|||
|
|||
|
Me too.
If you got a good 6BG6 in your stash it should sub in a pinch.
|
|
#9
|
||||
|
||||
|
Quote:
I'll try it now... |
|
#10
|
||||
|
||||
|
Put in the 6BG6 for a test...
Finally got a quick light up on the screen! Not very bright though, and then screen dies after 30 seconds... At least it shows something starting up! |
| Audiokarma |
![]() |
| Thread Tools | |
| Display Modes | |
|
|