Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Early B&W and Projection TV

Notices

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #9  
Old 04-17-2020, 03:52 PM
JohnCT's Avatar
JohnCT JohnCT is offline
VideoKarma Member
 
Join Date: Jan 2020
Posts: 749
Quote:
Originally Posted by Magnavox300 View Post
I checked the ion trap, put it in both ways, still nothing...
Checked the resistors under the 1B3, the 470K is good, but the 2.7 ohm is reading 5.7...Not sure if that would matter?
Removed the doorknob cap, it's 500PF at 20,000 volts.
Can I test it like it is, or will it fry my multimeter?
Wonder if I could bypass that cap and run the set to see if I get a picture, or is that crazy?
You can test the cap with a meter for value if your DMM reads capacitance. I don't know too much about doorknobs but they may read OK for value but start turning into resistors when you put a lot of voltage across them. Maybe someone here can address that. Because they're ceramic, I don't think they get leaky like paper caps do with voltage across them, but I'm not positive.

If the doorknob reads like a resistor on your ohmmeter, it's bad.

Of course, don't put any meter in the running circuit unless it's a HV probe.

John
Reply With Quote
 


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 04:24 PM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.