Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Rectangular Screen Tube Televisions

Notices

We appreciate your help

in keeping this site going.
Reply
 
Thread Tools Display Modes
  #1  
Old 03-15-2020, 11:13 PM
Electronic M's Avatar
Electronic M Electronic M is offline
M is for Memory
 
Join Date: Jan 2011
Location: Pewaukee/Delafield Wi
Posts: 15,496
On sets where the IF stages are hand wired disturbing the lead dress can ruin the alignment which is not something you want to mess up.

It might be a good idea to find a 5 tube AM radio and make that your first project. The average monochrome TV is 5x as complex as an AM radio but uses similar parts so if you make a mistake Tracing it down from the schematic is much less difficult.

Phill's old radios on the internet has a lot of good beginner info and detailed write ups with pictures of TV and radio restorations he has done.

The original trans is probably shot, but it might not be. If the B+ line in that set has a hard short on it (say from a shorted original lytic cap) and you didn't pull out the 5U4 before power up the trans could just be complaining of the overload.... sometimes if you overload a transformer till it smokes but don't run it too long it will survive, but the odds of that are not high.

Good luck on your project.
__________________
Tom C.

Zenith: The quality stays in EVEN after the name falls off!
What I want. --> http://www.videokarma.org/showpost.p...62&postcount=4
Reply With Quote
  #2  
Old 03-15-2020, 11:16 PM
BandDirector
Guest
 
Posts: n/a
Quote:
Originally Posted by Electronic M View Post
On sets where the IF stages are hand wired disturbing the lead dress can ruin the alignment which is not something you want to mess up.

It might be a good idea to find a 5 tube AM radio and make that your first project. The average monochrome TV is 5x as complex as an AM radio but uses similar parts so if you make a mistake Tracing it down from the schematic is much less difficult.

Phill's old radios on the internet has a lot of good beginner info and detailed write ups with pictures of TV and radio restorations he has done.

The original trans is probably shot, but it might not be. If the B+ line in that set has a hard short on it (say from a shorted original lytic cap) and you didn't pull out the 5U4 before power up the trans could just be complaining of the overload.... sometimes if you overload a transformer till it smokes but don't run it too long it will survive, but the odds of that are not high.

Good luck on your project.
Thanks! I think the transformer itself is shot, the inside (if you look at some of the links above you can see it) has burned more often than just my testing it about 5 times.
Reply With Quote
  #3  
Old 04-02-2020, 10:19 AM
Kevin Kuehn's Avatar
Kevin Kuehn Kevin Kuehn is offline
Workin' Late Again
 
Join Date: Jan 2011
Location: WI
Posts: 3,976
Quote:
Originally Posted by Electronic M View Post

It might be a good idea to find a 5 tube AM radio and make that your first project. The average monochrome TV is 5x as complex as an AM radio but uses similar parts so if you make a mistake Tracing it down from the schematic is much less difficult.

Phill's old radios on the internet has a lot of good beginner info and detailed write ups with pictures of TV and radio restorations he has done.
Not my intention to rain on your parade, but I highly suggest you heed the above advice and find yourself a transformer powered tube radio so you can learn the basics of electronics on a much less complicated set. I went back and read your introductory post, and IMO having some experience with antique and vintage telephones, cameras, and a few Edison cylinder phonographs are hardly credentials for the project you've undertaken. I understand the temptation to dive right in, but electronics is truly one of those fields where if you don't learn first, your basics, you'll forever be walking in the dark. Up until early computers, televisions were still considered one of the most complex electronic systems in existence. As far as discrete circuitry goes, they're still very high on that list.

Last edited by Kevin Kuehn; 04-02-2020 at 10:23 AM.
Reply With Quote
Reply


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 07:52 AM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.