![]() |
|
#13
|
||||
|
||||
|
OK remember this one. Its common to all brands.
The 3 color outputs are supplied with apx 200V. There is an electrolytic off it. Usually 4.7 or 10 mfd @350V. On your set IIRC there is a big can along the front of the chassis. It has two sections. One abt 800mfd the other is the one you want. Just cut the wire off the 10mfd section & install a new one to the wire. The 800mfd stays in. RCA got about $20 for the cap so thats how we did it. Symptoms are any of following. Jail bars Retrace lines Pix dark at left & gets brighter to the right Too bright Streaking / bad CRT look Pix is just not right 73 Zeno ![]() LFOD ! |
| Thread Tools | |
| Display Modes | |
|
|