![]() |
|
|
|
#1
|
||||
|
||||
|
Quote:
|
|
#2
|
||||
|
||||
|
Quote:
|
|
#3
|
||||
|
||||
|
Its the 2 on the forward board with the IF's. they have vieo, sync & AGC
IIRC. A fresh tube will fool you with a fix but soon gives problems again. Easy to change with the right socket. Just dike them apart & pull one pin at a time like teeth. |
|
#4
|
||||
|
||||
|
The two tubes in the red rectangle? The one which I changed twice, is V202, the symptom was loss of horizontal lock. I changed it first in 2014, and again in 2019. The tube I changed was a replacement RCA tube, which had been changed by an RCA service center some time in the 70s. The TV was very low hours when I got it. I should order a couple sockets to have on hand, I would never have suspected the socket itself could go bad. V202 seems to run quite hot, but since the set works properly I just sort of assumed that must be normal.
Last edited by maxhifi; 01-06-2020 at 10:46 AM. |
|
#5
|
||||
|
||||
|
Yes they are the ones. Also try GE or Zenith ( GE made EIA 188 IIRC) tubes.
The RCA replacements wasnt as good. We used to buy the Zeniths by the gross for 29 cents, list was near $3 IIRC. Zeno ![]() Quote:
|
| Audiokarma |
|
#6
|
||||
|
||||
|
Quote:
Wish I could get some now for 29 cents, this set uses 5 of them! |
![]() |
| Thread Tools | |
| Display Modes | |
|
|