|
|
|
|
|
#1
12-14-2019, 10:09 PM
|
|||
|
|||
|
OK Today I turned it on and I have a problem I'm hoping we can get it solved.
As you can see in the picture, it looks like severe vertical fold over. The Vertical height works and as shown is maxed out, and all the other controls work properly. While I wait for suggestions, I'm going over the Vertical circuit to see if I messed up a component or put it in the wrong place. I'm using a 3RP1 right now. The CRT that came with the TV looks to be gassy and doesn't display a raster. Thanks guys. 
|
|
#2
12-15-2019, 12:08 AM
|
|||
|
|||
|
Found the problem. I inserted a 4.7K instead of a 4.7M resistor. R96 in the Sams. On to alignment.
 
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
