![]() |
|
#11
|
||||
|
||||
|
Quote:
Vertical not filled and non-linear: put a test pattern (in a pinch end credits with even spacing between lines when viewed on a better set will do) on screen and adjust vertical height and linearity simultaneously (may need to juggle vertical centering too)...If you can't get a full linear vertical sweep check resistors I the vertical. The left vertical lines are probably horizontal drive lines...try adjusting horizontal drive...If that don't do it your probably going to need to adjust the horizontal osc waveform with an oscilloscope.
__________________
Tom C. Zenith: The quality stays in EVEN after the name falls off! What I want. --> http://www.videokarma.org/showpost.p...62&postcount=4 |
| Thread Tools | |
| Display Modes | |
|
|