![]() |
|
|
|
#1
|
||||
|
||||
|
Shango just started on a similar one.
https://www.youtube.com/watch?v=hqH8dZuUuoQ If yours is solid state it will need every small electrolytic in the hoz & vert & every control cleaned. They were that way even at 5 yrs old. They will work good then. 73 Zeno ![]() LFOD ! |
|
#2
|
||||
|
||||
|
It looks to be all tubes and no transistors.
Last edited by liammc00; 02-13-2020 at 10:31 AM. |
|
#3
|
||||
|
||||
|
I recently got around to working on this old sears tv and have made some good progress. I have recaped the tv. The tv now makes a pretty watchable picture but the sound is still not working right. The sound is very staticy like it's tuneing in a very weak signal.
I need to test the following tubes 6gh8 detector amp-vert mult and 6hz6 audio detector. My tube tester is a knight 600B and I do have the books(manuals). I couldn't find these tubes listed in the books I have. So I'm stuck at the moment and if any one knows how I can tests these tubes in my tube tester it would be much appreciated. |
|
#4
|
||||
|
||||
|
For the tester get a tube substitution guide & see if any listed subs
are there & test it that way. May not be perfect but it should show up a really bad tube. https://www.ebay.com/itm/25507945015...QAAOSw-Xdg90sh Audio tips A HISS like a weak FM station is the audio IF stage. A BUZZ or ticking is the audio detector stage. The buzz can be effected by the ACG, fine tuning & your source. 73 Zeno ![]() LFOD ! |
|
#5
|
||||
|
||||
|
Quote:
|
| Audiokarma |
|
#6
|
||||
|
||||
|
6GH8's & their cousins #GH8 were probably the worst tube
ever built. Some RCA color sets used 5 of them & after a few yrs they would be weak or leaky. Always suspect them ! Another tube checker tip. The first number of a tube is the filament voltage. A 6GH8 is the same as a 5GH8 or a 4GH8. Just the filament needs to be set to the proper voltage to test. You can also smoke out a bad tube by turning up the filament one notch ( say from 6-7volts) this can find leaky tubes that act up after the set runs a while & gets REAL hot inside. BTW You may be tempted to adjust the transformers in the audio. DOO NOT do it unless you take precautions ! AND dont change disc caps. They almost never go bad ! 73 Zeno ![]() LFOD ! |
|
#7
|
||||
|
||||
|
Quote:
|
|
#8
|
||||
|
||||
|
Quote:
If the elder-boss wasn't in to turn them away for that reason, I would write them up and quietly source that 4DK6 (or whatever) at home, then say "hey look what I found?" and if the boss was in that day, he'd say it's a "bastard" number he did not remember ordering. The bad caps responded to freeze spray back then, dirty pots responded to Lube a trol.
__________________
"When resistors increase in value, they're worthless" -Dave G Last edited by DavGoodlin; 09-27-2022 at 05:30 PM. |
![]() |
| Thread Tools | |
| Display Modes | |
|
|