Quote:
Originally Posted by Rocket
Got a question about properly doing the HV setup. I will be ready to put the chassis in for a test run in the next few days and I want to get this set correctly as one of the first things on my list. I have been reading up on the Sams instructions. Its my first time doing a HV setup so I don't want to botch it and get everything connected up correctly.
I drew up a little thing and attached it.
Please correct me if I am wrong, I pull the top of the horizontal output tube and have my meter in series with that lead as well as a capacitor in series with my meter. Then adjust to get below 210ma while maintaining 24kv on the picture tube anode at normal brightness setting.
|
the Horz current setting is on the CATHODE , not the plate
you will have to interrupt its path to ground. (pin 3)
this may help explain
https://www.boxcarcabin.com/rcacathode.htm
04-10-2019, 07:16 PM
Threaded Mode