Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Things with Motors

Notices

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #11  
Old 03-15-2019, 07:42 PM
MIPS's Avatar
MIPS MIPS is offline
VideoKarma Member
 
Join Date: Jun 2014
Location: West Canadia
Posts: 1,023
OUCH

So my first tank-to-empty calculation was done today when I started stalling down the hill to the highway. Good thing there's a gas station down there.

70L of gas, at $1.29CAD/L it cost $85.38 to fill the tank to full.
70L of gas with short highway driving, mainly city driving and hills everywhere in between lasted 9 days and allowed the car to travel 391km.

My math puts it at 15.75MPG at a cost of around 21 cents per kilometer.
Not.....great...but the Tracker was doing 21MPG when it was retired and the engine still needs a full tune-up, so there's likely improvements in those numbers once things are baselined and properly set. A bunch of that work starts tomorrow when the plugs, distributor rotor and cap, the cables and the smaller diameter vacuum lines are replaced followed by resetting of the ignition timing. This also gives me my first chance to liik into cylinder compression to verify if the source of my PCV issues are bad blow-by or something else. I have now verified there's 18 InHG present at the PCV valve but with the breather plugged I cannot get the crankcase to pull a vacuum below 1 InHG, which isn't enough to overcome the seemingly small amount of blow-by at unloaded revving that pushes the case pressure above 1PSI.

A replacement Sol-Vac solenoid has also been sourced and ordered. What I was not able to find however was a repalcement dashpot as mine is completely missing. The closest thing I could find was the Carter 202-462 (AMC 8127323) but it's listed for the 2BBL, not the 2BBD and I don't know what the difference is.


Edited: aaaaah drat. I tried to test fit my compression tester and the threads are not long enough to properly fit the 258 block. I can make it barely thread in with the O-ring removed but then the readings will be unusable due to a poor seal.

Last edited by MIPS; 03-15-2019 at 08:41 PM.
Reply With Quote
 


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 10:12 PM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.