Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Early B&W and Projection TV

Notices

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #12  
Old 02-11-2019, 05:50 PM
old_tv_nut's Avatar
old_tv_nut old_tv_nut is offline
See yourself on Color TV!
 
Join Date: Jul 2004
Location: Rancho Sahuarita
Posts: 7,814
Quote:
Originally Posted by jr_tech View Post
Interesting, thanks for posting! I suspect that they are driving the first two stages of the if amp with a different level of agc (through the dc amplifier, v11) than the rf stage (direct from the local/distant switch) to optimize signal to noise ratio at a given total gain. This is just a WAG.

jr
I haven't traced it through, but if what you surmise is the case, it's quite normal for TV AGC design.

This is called tuner AGC "delay." This doesn't mean a time delay, but that the tuner runs at full gain for weak signals so that the noise figure is maximized [EDIT: I meant minimized, of course]. The tuner AGC gain reduction starts only when the IF AGC gain reduction has already had some effect. In the low signal range (I seem to recall, typically below 1 millivolt RF) the IF AGC is active by itself. Then, above that level, AGC gain reduction is also applied in the tuner.

An alternative, which was never used in TVs as far as I know, is to run both the tuner and IF at max gain for as large a range as possible and use a PIN diode attenuator at the input to adjust signal level.

TVs actually get pretty poor noise figures when the signal is strong and tuner AGC is active, but as long as the video signal-to-noise ratio is great enough to make the noise invisible, it's OK.
__________________
www.bretl.com
Old TV literature, New York World's Fair, and other miscellany

Last edited by old_tv_nut; 02-11-2019 at 06:07 PM.
Reply With Quote
 


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 12:08 PM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.