Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Early B&W and Projection TV

Notices

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #10  
Old 02-03-2019, 11:29 PM
Crist Rigott Crist Rigott is offline
VideoKarma Member
 
Join Date: Oct 2015
Location: Waxahachie, TX
Posts: 1,519
I changed some resistors that were in some if the IF cans and in M7. Basically, they were 5% and each one was 10-11% out-of-tolerance.

Here is the schematic of the 2 IF cans that had resistors. L32 and L33. Both in the 1st IF stage. Each of these 2 cans had capacitors along with M7. And each can used different types of capacitors. I'll show some pics.



Here is L32. The 22K resistor was 10% out-of-tolerance and was replaced with a 1W 22K 5% carbon film resistor. The caps were disc.



Here is L33. The 4.7K resistor was 11% out-of-tolerance and was replaced with a 1W 4.7K carbon film resistor. The 2 caps were a dual mica cap. This cap used mica film just like a trimmer cap. I tested the 100pf side and got 102pf. I couldn't test the 13pf side due to my checker doesn't go down that low.







And finally M7. See schematic in a few previous posts. The 8.2K 5% resistor was 7% out-of-tolerance and was replaced with a 1W 8.2K carbon film resistor. Both Riders and Sams schematics showed M7 using a 10K resistor. I decided to use what was actually used. The caps in this unit were like "dogbone" type. Again all 3 cans used different types of caps.

Reply With Quote
Audiokarma
 


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 05:31 PM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.