Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Diagnostic & Test Equipment

Notices

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #20  
Old 12-16-2018, 12:41 PM
AlanInSitges's Avatar
AlanInSitges AlanInSitges is offline
VideoKarma Member
 
Join Date: Nov 2017
Location: Sitges, Catalonia, Spain
Posts: 451
We. Have. High voltage! There were a few dodgy-looking solder joints around the horizontal oscillator tube socket; I repaired all of them, powered back on, and:



So, it's a looong way from working, but every bit of progress is encouraging.
  • There's about 300V of boost, and HV of about 9.5kV.
  • The H frequency is way off (way too low), and you can't see very clearly in the photo but the horizontal has a big bright line down the middle. The raster is only about 1cm high, and awfully jiggly.
  • Cranking on the CALIBRATE control varies the pitch and intensity of the horiz oscillator, with a tiny bit of change on screen but not much.

At this point it all seems solvable, and it's probably time to start replacing those capacitors and checking resistors. On a whim I checked C30 (it's 390pf in my model) and it's right on the money. I connected a frequency counter to the horiz drive socket and it says 12.925khz. If that is correct, it's not a small amount.
Reply With Quote
Audiokarma
 


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 05:29 PM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.