|
|
|
#7
10-24-2018, 11:15 PM
|
||||
|
||||
|
They used the same anode connector for most CRTs made throughout the years. If the lead somehow is bad one from a 1980's-2000's junk SS CRT set can be subbed. If your game to swap the connector to a new lead then non-resistive spark plug wire from an auto parts store could also work. Any wire with insulation rated 30-50KV will work in most B&W sets. The average CRT has 1mA max anode current so even thin conductor wire can handle that.
__________________
Tom C. Zenith: The quality stays in EVEN after the name falls off! What I want. --> http://www.videokarma.org/showpost.p...62&postcount=4 Last edited by Electronic M; 10-24-2018 at 11:19 PM. 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode