![]() |
|
#7
|
||||
|
||||
|
I got it working properly. It needed just the recap and a full careful alignment, as
it was badly out. Of course it didn't work well at first ... hum in the picture. Arggggh ... it was a ground loop in my modulator setup. Looks good now, nice sharp picture, though still retrace lines in dark low contrast pictures. Only one problem: the brightness control could not turn down far enough. A zener diode in the grid lead pulled down to the -120 supply with 1 megohm did the trick. One could of course pull the cathode up more, but that would get it fairly close to the heater-cathode rating of the CRT. |
| Thread Tools | |
| Display Modes | |
|
|