Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Diagnostic & Test Equipment

Notices

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #5  
Old 07-17-2017, 12:24 AM
Winky Dink's Avatar
Winky Dink Winky Dink is offline
VideoKarma Member
 
Join Date: Apr 2010
Location: Meridian, Idaho.
Posts: 583
Adapting the 7053 to a 6BK4

I now have some idea about what “beam current” is and how the CRT checker measures it. The Beltron 808A instructions say that .85 mA is the minimum for an acceptable CRT. I assume that the Philco 7053 “weakest” reading would be similar to the Beltron’s minimum performance level. When I tested the 12LP4 previously with the Beltron, the reading was in the neighborhood of .45 mA. At the 7053’s “weakest” setting, the 12LP4 may be producing only half of the beam current needed to get the neon lamp glowing.

Of the three suggestions for checking the 7053 beam current test function, two are impractical. I’m not going to look for a working TV, and my multimeter’s limitations preclude a reliable current reading at the needed level.

The third suggestion was to test a 6BK4 in place of a CRT. I can get a 6BK4 and adapt the 7053’s Octal socket to its base. I thought that would be straightforward, but I am confused about the 7053 instructions.




The heater, grid, and cathode connections are straightforward, but which 7053 pin is used for the anode, and does it connect to the 6BK4 cap?
__________________
Winky Dink
Damn the patina,
Full speed ahead!
Reply With Quote
Audiokarma
 


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 02:57 PM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.