Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Antique Radio

Notices

We appreciate your help

in keeping this site going.
Reply
 
Thread Tools Display Modes
  #1  
Old 07-13-2017, 10:34 AM
dieseljeep dieseljeep is offline
VideoKarma Member
 
Join Date: Jul 2010
Posts: 7,562
Quote:
Originally Posted by Tubejunke View Post
I would say the biggest thing that was going on there was that I had the transformer wired wrong in that I had the entire heater network including rectifier wired on a single tap. I couldn't understand why heater voltage measurements were a bit over 7 volts. That number may be skewed as I was using a slightly reduced voltage.

Later I noticed a pair of wires that had heat shrink on them with no label and for giggles put my VOM on them and found that it was a 6v tap with small conductors. So I decided that they would naturally be for the single heater of the 6X5. As far as the other pair I was using goes, I just moved the large conductor that was marked 6.3 or something like that to the "input" of the heater network and bam, I had 6.3 everywhere that I should.

As far as caps go, there was only one 47mfd as I think a 40 is what the schematic calls for, but the rectifier is of different specs, so all of that is likely different. Seems like my Silvertone with a 6X5 has a 16 and an 8mfd (maybe). EVERY paper cap was a resistor. Not on the verge or any variation of a bad cap. They were petrified. I added a 10mfd cap to the filter network and pulled all but a tiny bit of hum out. So far, so good. It runs cool and strong. Some heat after say 30 min, but that's normal. Thanks so much for the great help. I'm glad you came in to say hi!
That transformer configuration wasn't shown on the schematic, but it was listed on the parts list as an alternate. The chassis, I removed it from has the first audio tube, a 7X7 heater was using this center tapped winding, probably to minimize hum. I sealed it off because it seemed to only be good for one 300ma tube.
It's always a little harder to subsitute an important part like a power transformer and it does require a little trial and error.
Reply With Quote
Reply


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 02:05 AM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.