Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Rectangular Screen Tube Televisions

Notices

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #3  
Old 06-05-2017, 08:48 PM
Adam's Avatar
Adam Adam is offline
VideoKarma Member
 
Join Date: Oct 2005
Location: Phoenix, AZ
Posts: 2,383
I eventually found out the problem was that the horiz centering control was open (well mostly it read about 4 megs across it). It's on a single unit with the vert height and horiz width, those controls were ok. I removed it, and thought maybe if I cleaned it it would work, but some of the conducting material was actually worn away and I couldn't repair it. (The control is in the 1st pic). I wound up removing the 3 pins from the centering control, and resoldering the rest of the multiple control unit back in. The adding a fixed resistor across the bottom of the chassis to replace the centering control. (next pic) - I used 3k.

By this time the wire to the HO tube plate cap (which was very brittle) just broke - but I had one of these wires with the tube cap attached nos in a plastic bag and I replaced it.

Finally I had to take apart the broken on/off switch. The piece of metal in there actually doing the switching was partially worn away, but by turning it upside down I could use the other side and make it work (next pic)

The TV really working with it's own horizontal oscillator is the next pic after that.

Last edited by Adam; 10-14-2018 at 08:33 PM.
Reply With Quote
 


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 12:50 AM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.