![]() |
|
|
|
#1
|
||||
|
||||
|
Done.
__________________
Tom C. Zenith: The quality stays in EVEN after the name falls off! What I want. --> http://www.videokarma.org/showpost.p...62&postcount=4 |
|
#2
|
|||
|
|||
|
thanks!
|
|
#3
|
||||
|
||||
|
Give us a photo of the antenna as mounted inside the back - I've got a lot of rods, but will need to know how the ball is mounted - clamp, v-pinch, or riveted.
As to the UHF tuner, is it a clutch style or gearbox (whitish round assembly in line with the shaft at the front of the tuner)? A pix would also help. ES85 or EP85-something tuner - all the solid state GE UHF tuners are non-serviceable, but the mechanicals can be transplanted. I'll pull the Sams if I have it and see what the part number is for the UHF knob - I have a bunch of older GE Utica/Syracuse knobs - what plant is mentioned on the back, possibly molded in the neck bell on the back? Any parts I have are yours for postage only - I have no use for most of them.
__________________
Brian USN RET 22YRS (Avionics/Cal) CET-Consumer Repair and Avionics ('88) "Capacitor Cosmetologist since '79" When fuses go to work, they quit! Last edited by Findm-Keepm; 05-04-2017 at 06:49 PM. Reason: 85 vs 76 - correction |
|
#4
|
||||
|
||||
|
For the tearing try running a weak signal & see if it
gets better. If so look at AGC. If not horz AFC diode area. The UHF is the drive mech. Its replaceable, IIRC just clips in place. Very common fail. Antenna probably is ball & rod clamped in a C shaped mount. You could change the ball & rod or just the rod. Finding the right size is the trick. Keep in mind these sets were built to just run & sell cheap. The parts count is very low & it dont take much to cause trouble. Shows were the name " Good Enough" came from. 73 Zeno ![]() LFOD ! |
|
#5
|
||||
|
||||
|
I've got the UHF knobs - both the outer and inner. If you'll post pictures of how the antenna mounts in the back, I can probably make the trifecta - all for postage only.
UHF knobs are ES43X490 (inner) and ES43X491 (outer)
__________________
Brian USN RET 22YRS (Avionics/Cal) CET-Consumer Repair and Avionics ('88) "Capacitor Cosmetologist since '79" When fuses go to work, they quit! |
| Audiokarma |
![]() |
| Thread Tools | |
| Display Modes | |
|
|