Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Vintage TV & Radio Tech Forum

Notices

We appreciate your help

in keeping this site going.
Reply
 
Thread Tools Display Modes
  #1  
Old 03-17-2017, 08:56 AM
Electronic M's Avatar
Electronic M Electronic M is offline
M is for Memory
 
Join Date: Jan 2011
Location: Pewaukee/Delafield Wi
Posts: 15,496
How thick was the wafer? they are usually are as thick as the bottom bump in the side and have a black rubber sheet in them to act as a seal. Once you get the wafer and terminals out you should see the bottom of the plate/dielectric roll (and possibly tar). If the roll ain't loose I use a cork screw to remove it.

I gave up trying to un-wire and un-crimp the bottoms a good while ago....I kept getting bad cuts on my hands doing the un-crimp plus all the un-wiring/rewiring is tedious. What I do is on cans that have a cardboard sleeve is pull off the sleeve, cut the can off ~1/2" up, drill ~5 VERY small holes through the wafer, for the leads, install new caps and reinstall the cardboard sleeve(can top optional). Cans without cardboard I like to use metal foil duct tape to rejoin the can top. Under chassis cans I don't bother with the tops.
__________________
Tom C.

Zenith: The quality stays in EVEN after the name falls off!
What I want. --> http://www.videokarma.org/showpost.p...62&postcount=4
Reply With Quote
Reply


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 05:57 PM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.