Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Early B&W and Projection TV

Notices

We appreciate your help

in keeping this site going.
Reply
 
Thread Tools Display Modes
  #1  
Old 02-09-2017, 09:43 PM
Crist Rigott Crist Rigott is offline
VideoKarma Member
 
Join Date: Oct 2015
Location: Waxahachie, TX
Posts: 1,519
I cleaned up the adjustable coils on the top of the chassis in preparation to solder the caps to the chassis. I used my 150 soldering iron to apply a small amount of solder to form a nice fillet.



I then noticed that the hold down screws on T107 were over torqued. It looks awful.



So I pulled the transformer and disassembled it. I straightened the screws. While I had it apart I dusted it off and cleaned it gently with some alcohol. These pics are before I cleaned the coil.





I reassembled the transformer and cleaned up the case and terminals. Ready to install.



Re-installed and ready to wire. I'll do that later while I'm recapping etc. I also cleaned up the case on T108.



Next up will be to paint the top transformer cover. The transformer underneath looks very good.

My order from Digikey came in already and while the transformer paint is drying, I'll re-stuff the caps.
Reply With Quote
  #2  
Old 02-11-2017, 07:13 PM
Crist Rigott Crist Rigott is offline
VideoKarma Member
 
Join Date: Oct 2015
Location: Waxahachie, TX
Posts: 1,519
Time to re-stuff the E-Caps!

There are 5 of them. The ones that came off the set are on the left and what I'm going to use is on the right. 4 of them use the cardboard covers. One cardboard cover on a shorter caps was already removed when somebody did the partial restoration.

What I plan on doing is to use 5 new bases because I don't want the twisty mounting ears to break off when installing them in the chassis. The cans that use the cardboard covers will be cut off about 1/2 above the base. Then I'll epoxy a PVC sleeve to the base. Install the new caps and slide on the cutoff can. Then slide on the cardboard cover.

The 1 E-Cap that does not have a cover, the can will be cut off right at the base. The base and can will be trued up and again a PVC sleeve will be epoxied to the base. I'll install the new caps, and slide on the polished up can.

I'm using all Nichicon 105 degree caps and most are at least 10,000 hour caps.

Reply With Quote
Reply


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 07:44 PM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.