Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Early B&W and Projection TV

Notices

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #10  
Old 02-07-2017, 07:12 PM
Crist Rigott Crist Rigott is offline
VideoKarma Member
 
Join Date: Oct 2015
Location: Waxahachie, TX
Posts: 1,519
I got the schematic and Wiring/Parts Placement Diagram enlarged to 24 x 36. Just right!

I then started to work on the chassis. It is bit grimy and it has a layer of white corrosion all over. I think the plating did its job! To clean the chassis right, I decided to pull what I could off the chassis.

I pulled the yoke, the big resistor in the HV cage, HV cage, flyback, and HV rectifier tube and mount, and the resistor cage.



The big resistor had opened some tome ago and was replaced by 2 10K 20W resistors.


Here is a picture of the bottom of the socket from the 1b3GT HV rectifier tube.


While removing the resistor heatsink cage I found a wire that had barely been soldered on to one the resistor's terminals!


I'll have more pics later. Lots came off the chassis.
Reply With Quote
Audiokarma
 


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 04:58 AM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.