Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Early B&W and Projection TV

Notices

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #8  
Old 01-31-2017, 01:08 PM
Kevin Kuehn's Avatar
Kevin Kuehn Kevin Kuehn is offline
Workin' Late Again
 
Join Date: Jan 2011
Location: WI
Posts: 3,976
Try hooking your scope to your 1077's video output and verify that it's capable of about a 5 volt video signal. You can also place a jumper between the 1077's positive bias supply over to the video jack which will allow you to vary the positive bias that the video signal rides on. You'll want your scope set to DC coupling to see the bias level change. That bias supply is floating from ground, so you'll need to ground it's negative side for positive bias. You can also reverse the plus and minus and end up with an adjustable negative bias.

[Edit] I just got to thinking - The 1077's 25 volt bias supply is going to be pretty sensitive to adjust down around 1.5v, so you might put something like a 100k resistor in series between the bias supplies positive output and the video out jack. That should knock the DC bias down to a more manageable level.

Last edited by Kevin Kuehn; 01-31-2017 at 01:43 PM.
Reply With Quote
 


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 01:06 PM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.