![]() |
|
#32
|
||||
|
||||
|
To get in the tuner pull the CRT (remove dial scales if in the way), remove the lamp holder/indicator needle assembly, remove ~6-8 screws from top cover and you will see the tuner shaft compartment. You may be lucky and only have the shaft off it's pivot/bearings. I had a thread on inductuner shaft repair let me see if I can dig it up....
EDIT: Found it!: http://www.videokarma.org/showthread...ght=inductuner It's been a year and my repair has held up to occasional use.
__________________
Tom C. Zenith: The quality stays in EVEN after the name falls off! What I want. --> http://www.videokarma.org/showpost.p...62&postcount=4 Last edited by Electronic M; 12-31-2016 at 06:36 PM. |
| Thread Tools | |
| Display Modes | |
|
|