![]() |
|
#6
|
||||
|
||||
|
Shorted how? It's an SPDT relay, right? The coil should measure a few ohms, and the NO contacts should be open, and the NC contacts should read as a short.
So what element(s) are shorted? Usually relays fail when the contacts either arc away or arc-weld themselves together. 5V to the relay coil (out of circuit) - do you hear a click? It is activated in circuit by the RL ON signal from the main board. Your 4A fuse blowing is from something shorted, but me thinks it's the bridge rectifiers....have you checked them?
__________________
Brian USN RET 22YRS (Avionics/Cal) CET-Consumer Repair and Avionics ('88) "Capacitor Cosmetologist since '79" When fuses go to work, they quit! Last edited by Findm-Keepm; 12-23-2016 at 10:20 AM. |
| Thread Tools | |
| Display Modes | |
|
|