![]() |
|
|
|
#1
|
|||
|
|||
|
If you want, you can run the big CRT without the doorknob temporarily, since the dag already provides a few hundred pf of capacitance. There'll be a slight voltage drop across the 1 meg resistor, probably not enough to notice.
Last edited by old_coot88; 10-15-2016 at 10:30 PM. |
|
#2
|
|||
|
|||
|
I just might do that. I'd like to work on the alignment next.
|
|
#3
|
|||
|
|||
|
Quote:
Quote:
But when all-glass CRTs with inner & outer dag came along, doorknobs weren't strictly needed but were sorta "grandfathered" along by convention for a while. Seems like, anyhow. In the set being worked on here, the doorknob serves mostly as mechanical mount for the 1B3.
|
|
#4
|
||||
|
||||
|
I was thinking the B+ also adds in series with the 1B3 rectified pulses, for a B+ boosted HV? Not sure it they were that hard up to get an extra 210v to the CRT anode, but it sure seems like the rectified flyback pulses are being stacked on top of the B+, relative to ground.
|
|
#5
|
|||
|
|||
|
But the HV value itself isn't gonna change whether the filter cap is grounded to chassis or to B+. Remember, it's an RF ground either way (the spikes being filtered are RF).
With the cap grounded to B+, the DC across the cap will be lower by the B+ value. The HV itself willl be unchanged. Last edited by old_coot88; 10-16-2016 at 12:55 PM. |
| Audiokarma |
![]() |
| Thread Tools | |
| Display Modes | |
|
|