![]() |
|
|
|
#1
|
|||
|
|||
|
Tom,
Firstly, thanks very much for the concise and detailed reply. OK, RF it is, at least at first. I do have a 'scope but no sweep/marker. So let's hope that replacing the caps and checking the resistors will get it done for the IF. If not, I wonder if I can find someone I could just send the IF to. As to video source, all I have is a laptop with VGA and HDMI. I live off the grid and so I just use a laptop as my PC. Although I do have enough power to run whatever I want now, the laptop is a legacy from when I first moved out onto the property and had little power storage. So, looks like I need something like this: https://www.amazon.com/ViewHD-Compos.../dp/B00LK95VNQ and run that into something like this: http://www.ebay.com/itm/Blonder-Tong...-/272304780489 I'll start cruising the thrift stores when I'm in town and pick up a small CRT TV set. Thanks again for the help! JOnathan Last edited by madlabs; 08-08-2016 at 12:50 PM. Reason: broken link |
|
#2
|
||||
|
||||
|
looks good to me. Every so often the BTs will have bad lytics...Little cheap ones. If it has video hum (dark horizontal bar rolling slowly vertically, often disturbing V sync when it goes off screen) or other issues look at the caps.
If you go wired run it at or near minimum RF power (output level), and use a 75ohm to 300ohm balun/matching transformer to connect to the set. If you plan to go wireless crank the output level to max and look for a youtube video on antennas by shango66. Start with video and audio levels at min turn up till distortion appears then back down a bit. Audio carrier I typically set low to mid and make sure it is not creating buzz. BTW: if you or anyone in a mile radius is using a DVT box for OTA reception transmit on an un-used channel so you don't jam other recievers....Come to think of it make sure your on an unused channel if you go wireless no matter what...I've had DTV interference with my TX experimenting on and near local channels.
__________________
Tom C. Zenith: The quality stays in EVEN after the name falls off! What I want. --> http://www.videokarma.org/showpost.p...62&postcount=4 Last edited by Electronic M; 08-08-2016 at 05:22 PM. |
![]() |
| Thread Tools | |
| Display Modes | |
|
|